Dreame D10 Plus Gen 2 Manual De Usuario página 15

Troubleshooting
EN
Problem Solution
Make sure that the robot is not set to the Do Not Disturb (DND) mode, which will prevent it from resuming
cleaning.
The robot will not resume cleaning after
The robot will not resume cleaning after you manually return the robot to the base station to charge, which
charging.
includes manually placing the robot on the base station or sending the robot to charge via the app, or the
robot itself.
Check whether the dust bag in the dust tank is full.
The base station cannot automatically
If the dust bag is not full, check whether there is any obstruction at the auto-empty vents of the robot, the
empty the dust box.
base station, or the dust box. If any, clean the blocked part in time.
Check whether there is water inside the water tank.
Clean the air hole on the water tank stopper.
No water comes out of the water tank,
or only a little bit comes out.
Clean the mop pad if it becomes dirty.
Make sure the mop pad is installed correctly according to the user manual.
Robot returns to the base station
DND mode prevents the robot from performing auto-empty tasks.
without performing auto-empty tasks.
For more support, contact us via https://global.dreametech.com.
26
Specifications
Robot
Model RLD32GD
Charging Time Approx. 6 hours
Rated Voltage 14.4 V
Rated Power 75 W
Operation Frequency 2400-2483.5 MHz
Maximum Output Power < 20 dBm
Under normal use of condition, this equipment should be kept a separation
distance of at least 20 cm between the antenna and the body of the user.
Base Station with Auto-Empty
Model RCDD0202
Rated Input 220-240 V 50-60 Hz
Rated Output 20 V 1 A
Rated Power
650 W
(during dust emptying)
EN
27