Publicidad
Idiomas disponibles
Idiomas disponibles
How to Use
EN
Turn On/Off
Press and hold the button
for 3 seconds to turn on the robot. The power
indicator should be illuminated. Place the robot onto the base station, the
robot should turn on automatically and begin charging. To turn off the
robot, move the robot away from the base station and press and hold the
button
for 3 seconds.
Fast Mapping
After configuring the network for the first time, follow the instructions in the
app to quickly create a map. The robot will start mapping without cleaning.
When the robot returns to the base station, the mapping process has been
completed and the map will be saved automatically.
Start Cleaning
Press the button
to start cleaning after the robot is turned on. The robot
will accurately map out a route, methodically clean along the edges and
walls, then finish by cleaning each room in an S-shaped pattern to ensure
a thorough job.
Note:
· It is recommended that the robot set out from the base station before
cleaning. Do not move the base station while the robot is cleaning. This
ensures that the robot returns to base station smoothly.
· After the robot completes the cleaning task and automatically returns to
the base station, the base station will start auto-empty. More settings can
be operated on the app.
14
Pause/Sleep
When the robot is running, press any button to pause it.
If the robot is paused for more than 10 minutes, it automatically enters
sleep mode. All indicators on the robot will turn off. Press any button on
the robot or base station, or use the app to wake up the robot.
Note:If the robot is paused and placed onto the base station, the current
cleaning process will end.
Auto Resume Cleaning
If the battery is too low, the robot will automatically return to the base
station to charge. After charging to the appropriate battery level, it will
resume unfinished cleaning tasks.
Note: To use this function, please open it in the App.
Do Not Disturb (DND) Mode
When the robot is set to Do Not Disturb (DND) mode, the robot will be
prevented from resuming cleaning and the power indicator will turn off.
DND mode is disabled by default at the factory. You can use the app to
enable DND mode or modify the DND period. The DND period is 22:00–
8:00 by default.
Note:
· The scheduled cleaning tasks will be performed as usual during the DND
period.
· The robot will resume cleanup where it left off after the DND period
expires.
How to Use
Spot Cleaning
When the robot is on standby, press and hold the button
for 3 seconds
to enable the spot cleaning mode. In this mode, the robot cleans a square-
shaped area of 1.5 × 1.5 meters around it and returns to its starting point
once the spot cleaning is completed.
Robot Restarting
If the robot stops responding or cannot be turned off, press and hold the
button
for 10 seconds to forcefully turn it off. Then, press and hold the
button
for 3 seconds to turn the robot on.
Use Mopping Function
It is recommended that all floors are vacuumed at least three times before
the first mopping session to achieve a better cleaning effect.
1. Dampen the mop pad and wring out excess water. Install the mop pad as
shown in the diagram.
2. Fill the tank with water.
Note:
· Do not use detergent or disinfectant.
· Do not fill the water tank with hot water as this may cause the water tank
to warp.
EN
15
Publicidad
