cecotec ENERGYSILENCE AERO 3600 INVISIBLE METALLIC STYLE Manual De Instrucciones página 48

ENGLISH
(Fig. 11).
Note: after installation, check that all parts are securely fixed.
Please note: before fitting the bulb, make sure that the fan is not connected to the mains.
11. Connect the wires as follows:
Figure 12
- Plug the receiver into the bracket with the flat side up.
- Insert the 3P connector of the bracket into the AC POWER INPUT socket of the receiver.
- Insert the 2P light connector from the fan motor assembly into the 2P LIGHT socket on the
receiver.
- Insert the 3P connector of the fan motor into the 3P MOTOR socket of the receiver.
- Connect the yellow/green 1P connectors of the fan motor assembly and the suspension
bracket.
12. Mount the canopy as shown above (Fig. 13).
Remote control
Fig. 14
1. Reconnect the mains supply from the electrical switchboard in the house.
2. Remove the battery-compartment cover of the remote control, insert the batteries, and
replace the cover.
Note:
- The remote control is powered by two AAA 1.5 V batteries.
- If the fan is not to be used for a long period of time, store the remote control in a dry place
where it will not be exposed to heat or direct sunlight. Also remove the batteries.
- The remote-control buttons control the speed and light of the fan.
Fig. 14 key
1. Power button (used to pair the remote control)
2. Clockwise rotation
3. Switch off the fan only
4. Light button
5. Counterclockwise rotation
6. Natural-breeze mode
7. Setting the speed
8. Timer
2H: the fan will automatically switch off after two hours of operation.
4H: the fan will automatically switch off after four hours of operation.
8H: the fan will automatically switch off after eight hours of operation.
48 ENERGYSILENCE AERO 3600 INVISIBLE METALLIC STYLE