cecotec ENERGYSILENCE AERO 3600 INVISIBLE METALLIC STYLE Manual De Instrucciones página 50

ENGLISH
- The receiver must be correctly installed in the fan mounting bracket.
- Remove the batteries from the remote control if you are not going to use it for a long period
of time.
- The isolation switch must be switched on.
- If the power is cut off (e.g. due to a blackout) the light will go out. When the power is
restored, the light will switch on again.
Receiver protection functions
- The DC motor has a built-in safety feature against blade or motor obstruction during
operation.
- During operation: if something obstructs the fan blades or motor, the motor will keep
trying to run and then stop operation after about 30 seconds of interruption. Remove
obstructions and restart the motor.
- To restart it: switch the fan off from the remote control and then switch it on again.
- The device will limit the maximum current output from the receiver/drive if the fan load
has increased abnormally.
Tips
1. If your fan runs automatically when you switch it on for the first time after installation, it
has memorised the previous factory setting. Use the universal mode or the learning code
matching mode, and the fan will be ready for operation.
2. If the fan or light does not work, reset the fan. To do this, turn it off for at least 5 seconds
and then turn it on again. Then, reset the learning code matching mode setting.
3. It is not possible to control more than one fan in the same room if they share the same
power supply.
If you want to separately control more than one fan in the same room, you must use
separate power supplies.
4. When the fan is switched on and starts running in either direction (clockwise or
counterclockwise), it will stop and change direction several times.
This is normal. The fan will take some time to perform the selected function and to start
up regularly.
4. CLEANING AND MAINTENANCE
1. Clean your fan periodically.
2. To clean, only use a soft brush or lint-free cloth to avoid scratching the finish.
3. Abrasive cleaning agents are not necessary and should be avoided in order not to damage
the finish.
50 ENERGYSILENCE AERO 3600 INVISIBLE METALLIC STYLE