ACO LipuJet P-RB Instrucciones De Empleo página 100

LipuJet - P -RB / - RD / - RM / - RA / - RAP
Installation
Push the securing fixtures [ 1 + 2 ] into
the openings
Mark the holes on the base.
Remove the securing fixtures [ 1 + 2 ]
from the openings
Drill and vacuum out holes for the
dowels. Insert dowels [ 3 ]
Push the securing fixtures [ 1 + 2 ] into
the openings
Place the washers [ 3 ] over the screw
[ 3 ] .
Screw the screws [ 3 ] into the dowels
[ 3 ] and tighten them crosswise by hand
2.17 Connecting hose assembly
Connecting hoses are supplied as loose items:
IMPORTANT Connecting hoses must be laid without kinks.
2.17.1 Connecting hose for pneumatic box and pitot tube
Connect the connecting hose
the pneumatic box (1) and to the pitot
tube (2):
100/ 454
as far as they will go.
.
as far as they will go.
.
Connecting hose for pneumatic box and pitot tube (fabric hose 6 x 3)
Connecting hose for odour trap and high-pressure pump (plastic suction and
pressure hose (0150.16.26), 20 x 14 x 3.9 bar, transparent, smooth, with wire
spiral)
Push the hose clamps onto the spigot
ends of the connecting hose.
Put the spigots on the hose nozzles
and fix them with hose clamps.
.
.to
1
2