ACO LipuJet P-RB Instrucciones De Empleo página 98

LipuJet - P -RB / - RD / - RM / - RA / - RAP
Installation
Requirement: Suction pipe [ 9 ] must be in a
vertical position after installation.
The fixed coupling [ 2 ] and blind
coupling [ 3 ] are mounted on the
suction pipe [ 9 ] on delivery.
Loosen one screw joint
section (8).
Place the bracket [ 5 ] with the hole on
the longer section
bolt of the loosened screw joint
IMPORTANT Do not tighten the screw
joint with a tightening torque of 20 N . m
(9) until you have completed step (11).
Attach the pipe clamp [ 8 ] to the suction
pipe [ 9 ] (still movable) (10).
Step (11):
98/ 454
on the upper
over the stud
Slide the washer [ 4 ] onto the screw
[ 3 ] and insert the screw [ 3 ] through
the hole in the bracket [ 5 ] .
Slide the washer [ 6 ] onto the screw
[ 3 ] and tighten the nut [ 7 ] onto the
screw [ 3 ] .
Screw the screw [ 3 ] into the threaded
sleeve of the pipe clamp [ 8 ] . Tighten
the nut [ 7 ] by hand.
Align the pipe clamp [ 8 ] horizontally
and tighten the screw joints of the
pipe clamp [ 8 ] by hand.
8.
.
9.
11.
10.