Installation; Location; Power Supply; Installing Welding Equipment - ESAB COOL 2 Manual De Instrucciones

US
7

INSTALLATION

The installation must be carried out by a qualified electrician.
This product is intended for industrial use. In a domestic environment this product
may cause radio interference. It is the user's responsibility to take adequate
precautions.
7.1

Location

Position the cooling unit such that its cooling air inlets and outlets are not obstructed.
7.2

Power supply

The cooling unit is supplied from the power source, see page 39.
7.3

Installing welding equipment

See installation instructions on page 39.
8

OPERATION

General safety regulations for the handling of the equipment can be found on
page 4. Read through before you start using the equipment!
8.1

Connections and control devices

5
4
bk12da
1 Switch for On/Off
1
2 Coolant filling
2
3 Min./max. of coolant
4 Connection RED for coolant (return) to
cooling unit.
5 Connection BLUE for coolant from cooling
unit
3
- 11 -
© ESAB AB2013