Filling With Coolant; Fault-Tracing; Ordering Spare Parts - ESAB COOL 2 Manual De Instrucciones

US
9.2

Filling with coolant

You are recommended to use ESAB coolant. See accessories, see page 44.
S
Fill with coolant.
(The fluid level must not exceed the
upper marking, nor must it be below
the lower marking)
Note! Coolant must be topped up if
connecting a welding gun or coolant
hoses that are 5 meters in length or
longer. When adjusting the water level
by topping up, the coolant hoses do
not need to be disconnected.
10

FAULT-TRACING

Try these recommended checks and inspections before sending for an authorized
service technician.
Error code
Poor cooling effect
11

ORDERING SPARE PARTS

Repair and electrical work should be performed by an authorized ESAB service
personnel. Use only ESAB original replacement and wear parts.
The COOL2 is designed and tested in accordance with International standards IEC 60974­2,
Canadian standards CAN/CSA­E60974­1 and US standards ANSI/IEC 60974-1.
On completion of service or repair work, it is the responsibility of the person(s) performing
the work to ensure that the product still complies with the requirements of the above
standards.
When ordering replacement parts, order by part number and part name, as
illustrated on the figure. Always provide the series or serial number on the unit on
which the parts will be used. The serial number is stamped on the rating plate.
bk12da
The coolant must be handled as chemical waste.
S
Clean the cooling element using compressed air.
S
Check the coolant level.
S
Check that the on/off switch on the cooling unit is set to ON.
Corrective action
- 13 -
BC_0303
© ESAB AB2013