Threading The Machine - Sears Kenmore 385.17626 Manual De Instrucciones

Tabla de contenido

Publicidad

Threading
the Machine
• Threading
the Machine
• Raise the thread
take-up
lever to its highest
position
by.turning
the handwheel
counterclockwise.
• Raise the presser foot lifter.
Place a spool on the spool pin, with thread coming
off as shown.
_
Draw the end of thread
around the upper thread
guide.
_
While holding
the thread
near the spool, draw the
end of the thread
down around
the check spring
holder.
,_3_) F irmly draw the thread up from right to left over
the take-up
lever and down into the take-up
lever
eye.
_)
Slide the thread
behind the needle bar thread
guide on the left.
6) Thread the needle from front to back or use a
needle threader.
We recommend
using the convenient
needle
threader(#200262101),
included
with your
machine.
• Drawing
up Bobbin Thread
_1_.Raise the presser foot.
Hold the needle thread
lightly with your left hand and rotate handwheel
counterclockwise
for one complete
turn.
@_ Bring the bobbin
thread
up by pulling the needle
thread
up.
_
Pull both threads
under and to the back of the
presser foot, leaving 4 to 6" (10 to 15cm)
of thread clear.
S
S
J
26

Publicidad

Tabla de contenido
loading

Tabla de contenido