DeWalt DWE4011 Manual De Instrucciones página 11

4-1/2" (114.3 mm
Type 1 guard
backing flange
abrasive cutting wheel
clamp nut
Cutting Wheels
Type 1 guard
backing flange
diamond cutting wheel
clamp nut
MOUNTING AND REMOVING (TYPE 27)
ONE-TOUCH
TM
GUARD (FIG. 4, 5) FIG.4
1. Press the guard release lever (H).
2. While holding the guard release lever open,
align the lugs (I) on the guard with the slots I
on the gear case (J).
3. Keeping the guard release lever open,
push the guard down until engage the lugs
and rotate them into the groove on the
gear case hub. Release the guard release
lever.
Sanding Discs 4-1/2" (114.3 mm) Sanding Flap Discs
rubber backing pad
sanding disc
threaded clamp nut
Type 27 guard
hubbed sanding
flap disc
Type 27 guard
backing flange
non-hubbed sanding
flap disc
threaded clamp nut
4. With the spindle facing the operator, rotate
the guard clockwise into the desired
working position. The guard body should
be positioned between the spindle and
the operator to provide maximum operator
protection.
5. For easy adjustment, the guard can be
rotated in the clockwise direction. NOTE"
The guard release lever should snap into
one of the alignment holes (K) on the
FIG. 5
10