_ WARNING: ALWAYS use safety glasses. Everyday eyeglasses are
NO T safety glasses. Also use face or dust mask if cutting operation is
dusty. ALWAYS WEAR CERTIFIEDSAFETY EQUIPMENT_
• ANSI Z87.1 eye protection (CAN/CSA Z94.3),
• ANSI $12.6 ($3.19) hearing protection,
• NIOSH/OSHA/MSHA
respiratory protection.
_WARNING:
Some dust created by power sanding,
sawing,
grinding, drilling, and other construction activities contains chemicals
known to the State of California to cause cancer, birth defects or other
reproductive harm. Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry
products, and
• arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you
do this type of work. To reduce your exposure to these chemicals:
work in a well ventilated area, and work with approved safety
equipment, such as those dust masks that are specially designed to
filter out microscopic particles.
• Avoid prolonged
contact
with dust from power
sanding,
sawing, grinding, drilling, and other construction activities.
Wear protective
clothing and wash exposed
areas with
soap and water. Allowing dust to get into your mouth, eyes, or
lay on the skin may promote absorption of harmful chemicals.
WARNING: Use of this tool can generate and/or disperse dust,
which may cause serious and permanent respiratory or other injury.
Always use NIOSH/OSHA approved respiratory protection appropriate
for the dust exposure. Direct particles away from face and body.
AWARNING:
Always wear proper personal hearing protection
that conforms to ANSI $12.6 ($3.19) during use. Under some
conditions
and duration
of use, noise from this product
may
contribute to hearing loss.
•
The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ..............
volts
Hz ............ hertz
min .......... minutes
---.
...... direct current
(_) ............ Class I Construction
(grounded)
[] ............ Class II Construction
................ (double insulated)
.../min ...... per minute
IPM .......... impacts per minute
SPM ........ strokes per minute
sfpm ........ surface feet
minute
A ............. amperes
W ............ watts
'_ ........... alternating current
.......... alternating or direct
current
no ........... no load speed
n ............. rated speed
............ earthing terminal
_ ............ safety alert symbol
BPM ....... beats per minute
RPM ....... revolutions per per
minute
SAVE THESE
INSTRUCTIONS
FOR
FUTURE
USE
Motor
Be sure your power supply agrees with the nameplate marking.
Voltage decrease of more than 10% will cause loss of power and
overheating. DEWALT tools are factory tested; if this tool does not
operate, check power supply.
COMPONENTS
(Fig.
1)
WARNING: Never modify the power tool or any part of it. Damage
or personal injury could result.