Intended Use; Assembly And Adjustments - DeWalt DWE4011 Manual De Instrucciones

FIG. 1
G
A. Spindle lock button
B. Spindle
C. Side handle
D. Backing flange
E. Threaded clamp nut
F. Guard
G. Slider switch
H. Guard release lever
INTENDED USE
This grinder is designed for professional grinder, sander, wire brush,
polisher or cut-off applications.
DO NOT use under wet conditions or in presence of flammable
liquids or gases.
This grinder is a professional power tool. DO NOT let children come
into contact with the tool. Supervision is required when inexperienced
operators use this tool.
ASSEMBLY AND ADJUSTMENTS
A WARNING: To reduce the risk of injury, turn unit off and
disconnect it from power source before installing and removing
accessories, before adjusting or when making repairs. An
accidental start-up can cause injury. FIG.2
An'ACHING SIDE HANDLE (FIG. 2) c
The side handle (C) can be fitted to either side of
the gear case in the threaded holes, as shown.
Before using the tool, check that the handle is
tightened securely. Use a wrench to firmly
tighten the side handle.
Rotating the Gear Case
(Fig. 3)
1. Removethe four corner screwsattaching
the gear case to motor housing.
2. Without separating the gear case from
motor housing, rotate the gear case
head to desired position.
NOTE: If the gear case and motor housing
become separated by more than 1/8"
(3.17 mm), the tool must be serviced and
re-assembled by a DEiWALTservice center.
Failure to have the tool serviced may cause
brush, motor and bearing failure.
3. Reinstall screws to attach the gear case to the motor housing.
Tighten screws to 18 in.-Ibs, torque. Overtightening could cause
screws to strip.