SURFACE GRINDING WITH GRINDING WHEELS (FIG. 9)
1. Allow the tool to reach full speed before
FIG.9
touching the tool to the work surface.
2. Apply minimum pressure to the work
} o2c°-()30
o
surface, allowing the tool to operate at
high speed. Grinding rate is greatest
when the tool operates at high speed.
3. Maintain a 20 °to 30 ° angle between the tool and work surface.
4. Continuously move the tool in a forward and back motion to avoid
creating gouges in the work surface.
5. Remove the tool from work surface before turning tool off. Allow
the tool to stop rotating before laying it down.
EDGE GRINDING WITH GRINDING WHEELS (FIG. 10}
,_WARNING:
Wheels used for cutting and edge grinding may break
if they bend or twist while the tool is being used to do cut-off work or
deep grinding. To reduce the risk of serious injury, limit the use of
these wheels with a standard Type 27 guard to shallow cutting and
notching (less than 1/2" in depth). The open side of the guard must
be positioned away from the operator. For
FIG. 10
deeper cutting with a Type 1 cut-off wheel,
use a closed, Type 1 guard. See the chart
on page 9 for more information. Type 1
guards are available at extra cost from your
local dealer or authorized service center.
1. Allow the tool to reach full speed before
touching the tool to the work surface.
2. Apply minimum pressure to the work
surface, allowing the tool to operate at
high speed. Grinding rate is greatest
when the tool operates at high speed.
3. Position yourself so that the open-underside
of the wheel is
facing away from you.
4. Once a cut is begun and a notch is established in the workpiece,
do not change the angle of the cut. Changing the angle will cause
the wheel to bend and may cause wheel breakage. Edge grinding
wheels are not designed to withstand side pressures caused by
bending.
5. Remove the tool from the work surface before turning the tool off.
Allow the tool to stop rotating before laying it down.
i_,WARNING: Do not use edge grinding/cutting wheels for surface
grinding applications because these wheels are not designed for side
pressures encountered with surface grinding. Wheel breakage and
injury may result.
SURFACE FINISHING WITH SANDING FLAP DISCS (FIG. 11)
3. Allow the tool to reach full speed before touching the tool to the
work surface.
2. Apply minimum
pressure to work
surface, allowing the tool to operate
at high
speed.
Sanding
rate is
greatest when the tool operates at
high speed.
3. Maintain a 5° to 10° angle between the tool and work surface.
4. Continuously move the tool in a forward and back motion to
avoid creating gouges in the work surface.
5. Remove the tool from work surface before turning tool off. Allow
the tool to stop rotating before laying it down.
MOUNTING SANDING BACKING PADS (FIG. 12)
A WARNING: Proper guard must be reinstalled for grinding wheel,
sanding flap disc, wire brush or wire wheel applications after sanding
applications are complete.
13