Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Arm tilt CC53M and CCT53M
It is possible to adjust the arm tilt in 3 different positions [Fig. 07].
1. Rotate the quick adjustment pins "A", located close to the rear wheels, by 90º [Fig. 08].
2. Adjust the arm to one of three positions, depending on the operator's preference.
3. Return the quick adjustment pins "A" to their initial position, leaving them two way switch to the
tube [Fig. 09].
Fig. 07
Cutting types
The equipment is 4 in 1, allowing the user to choose the destination for the cut grass: collection with
the grass collector, disposal with the lateral deflector, rear disposal or returning to the lawn in the form
of small fragments, used as natural fertilizer in the function recycler.
Assembling and using the grass collector
It is possible to use the grass collector to collect grass clippings automatically while you
are operating the mower.
Follow the following steps to assemble the grass collector:
1. To fix the grass collector, lift the rear deflector (10) and remove the plastic closing (11) found inside
the rear deflector [Fig. 10].
2. Insert the grass collector (12) into the fit on the arm supports (13). Release the rear deflector (10) so
that it rests on the grass collector (12) [Fig. 11].
3. Stop operation as soon as the grass collector is full.
4. To stop the engine, release the brake lever and make sure the mower has come to a complete stop.
5. To remove the grass collector, lift the rear deflector (10) and pull the grass collector (12) up and away
from the mower. Discard the grass clippings and replace the collector on the mower [Fig. 11].
11
22
A
10
Fig. 10
Fig. 08
10
12
A
Fig. 09
Fig. 11
Publicidad
