Publicidad
Idiomas disponibles
Idiomas disponibles
Traction lever CCT53M
Do not connect the equipment's traction mechanism while starting the engine.
The traction lever (16) is located on the upper arm, on the opposite side of the braking lever (7) [Fig. 16].
To activate the traction system, hold the braking lever (7) and the traction lever (16) pressed against
the upper arm [Fig. 17].
The traction mechanism is located at the bottom rear of the mower [Fig. 18]. If maintenance
on the traction belt is necessary, contact an authorized technical support network.
5
7
Fig. 16
Use on sloped land
These mowers should not be used on land with a slope greater than that indicated in the table below.
Model
CC46M
CC53M
CCT53M
Cutting height adjustment
1. Pull the cutting height adjustment lever (17) towards the
wheel [Fig. 19].
2. Move the lever to the desired cutting height position. There are
8 different positions, ranging from 25 mm to 85 mm in height.
3. Release the lever towards the chassis. For dense or irregular
lawns, move the cutting height adjustment levers to a higher
position. This will prevent you from cutting the grass too short.
5
Use
Domestic
Professional
Professional
7
Fig. 17
Maximum tilt in
continuous use
Up to 15º
Up to 15º
Up to 15º
17
EN
Fig. 18
Maximum tilt in
intermittent use
Up to 20º
Up to 30º
Up to 30º
Fig. 19
25
Publicidad
