Publicidad
Idiomas disponibles
Idiomas disponibles
SECTION E:
OPERATION
1. Open the Valve(s)
Open the valve(s) of the external fuel tank.
If using heater for the first time, press the Red float release button in order to
send fuel to the fuel sump and release.
NOTE: Make sure there is no fuel leakage from the fuel line or joints.
Also make sure fuel tank is not too high. See installation instructions.
NOTE: Red Float Release Button is for first time installation, or on rare
occurrences when the fuel tank is filled. This red button is to release the
fuel sump float. It does not prime the fuel into the sump. Pushing the Red
Float release Button, too many times or for too long of a period WILL
cause flooding of the fuel sump, which can result in a possible fire. Only
every push the Red Float release Button once, with a quick press of less
than one second.
3. Plug in the Heater
Plug in heater into 220V or 230V AC electrical outlet. (See SECTION A:
SPECIFICATIONS). On Display pre-set "Two Dashes" will be showing.
NOTE: Do not connect to an outlet shared with other appliances.
4. Set Clock
IMPORTANT: Clock on the heater must always be set to current time and day.
NOTE: " HOUR" or " MIN." button will change the time every one (1) unit.
Holding the button continuously will cause the time to change rapidly.
NOTE: In the event of a power failure (more than approx. 30 min.), all clock and
day may be cancelled.
5. Setting of the Time and a Day of the Week.
1) Current time is not set yet. (All signs light on solid.)
When the " MIN." button or " HOUR" button is pressed while the operation is stopped, all displays
except the colon ":" will be blinking.
When the " MIN." Button or the " HOUR" button is pressed again, the bar display ("Two Dashes")
changes to "0 00".
2) Setting of the current time
Press the " MIN." button to set minutes and press the " HOUR" button to set hours.
When pressing the " HOUR" button, the sign will change as follows.
" 0:00"
When pressing the " MIN." button, the sign will change as follows.
" 0:00"
Press the "SET" button to complete the set of the current time.
GB
5
BEFORE IGNITION
" 1:00"
···
"23:00"
" 0:01"
···
" 0:59"
" 0:00"
" 0:00"
···
···
ENGLISH
Red float release
button
Publicidad
