Adjusting The Front-To-Rear; Blade Slope - Toro TimeCutter Z5000 Manual Del Operador

G005278
1.
2.
Figure 41
Blades side to side 3. Measure here
Outside cutting edges
,
Measure between the outside cutting edges and
the flat surface (Figure 41). If both measurements
are not within 3/16 inch (5 mm), an adjustment is
required; continue with this procedure.
7. Move the left side of the machine. Loosen, but
do not remove, the rear loc_ng nut on the hanger
bracket (Figure 42).
,
Loosen the side loc_ng nut on the hanger bracket
just enough to allow the eccentric plate to be adjusted
(Figure 42). Use a 3/8 inch drive extension on a
socket wrench to manipulate the eccentric plate. Use
the wrench to reposition the height of the mower
deck and adjust to the desired height.
9. Stop the deck at the adjusted position and tighten
the side loc_ng nut on the hanger bracket to hold
the new position (Figure 42).
10. Continue leveling the deck t)37checMng the
front-to-rear blade slope; refer to Adjusting the
Front-to-Rear Blade Slope.
1
6
5
G005074
2
Figure 42
1. Hanger bracket 4. Eccentric adjustment plate
2. Rear locking nut 5. Socket wrench hole
3. Side locking nut 6. Socket wrench with 3/8
inch extension
Adjusting the Front-to-Rear
Blade Slope
Check the front-to-rear blade level any time you install
the mower. If the front of the mower is more than
5/16 inch (7.9 ram) lower than the rear of the mower,
adjust the blade level using the follovdng instructions:
1. Park the machine on a level surface and disengage
the blade control svdtch.
,
,
,
Move the motion control levers outward to the
park position, stop the engine, remove the key and
wait for all moving parts to stop before leaving the
operating position.
Check the air pressure of all four tires. If needed,
adjust to the recommended inflation; refer to
Chec_ng the Tire Pressure in Drive System
Maintenance, page 31.
Check and adjust the side-to-side blade level if you
have not checked the setting; refer to Leveling the
Mower from Side-to-Side.
5. Set the height-of-cut at position 3 [3 inch (76 ram)]
and carefu_y rotate the blades so they are facing
front to rear (Figure 43).
34