Dyna-Glo DGU951SSE Manual De Uso página 10

ASSEMBLY INSTRUCTIONS
1. Remove the eight pre-installed M5 x 12 (CC)
screws from the bottom of the cabinet assembly
(A) and attach each of the rear casters (B) using
four screws per caster. Remove the six
pre-installed M6 x 12 (BB) screws from the bottom
of the cabinet assembly and attach the front legs
(C) using three screws per leg.
Hardware Used (Pre-installed)
M6 x 12 mm
BB
Screw
CC M5 x 12 mm
Screw
2. CAUTION: This unit is HEAVY! Do not attempt
this step without assistance!
With the assistance of a helper, stand the smoker
Remove the four pre-installed M5 x 12 (CC)
screws from the back of the cabinet assembly (A)
and attach the rear handle (D).
Hardware Used
M5 x 12 mm
CC
Screw
1
x 6
x 8
2
x 4
10
BB
CC
BB
C
A
B
CC
D
A