Cameo Q SPOT 15 RGBW Manual De Usuario página 38

Tabla de contenido

Publicidad

IR REMOTE CONTROL / IR FERNBEDIENUNG / TÉLÉCOMMANDE INFRAROUGE / MANDO A
DISTANCIA POR INFRARROJOS / PILOT NA PODCZERWIEŃ / TELECOMANDO A INFRAROSSI
EN
In the system settings under "IR Remote", activate the control via infrared remote control (IR Remote On). Now, point the
infrared remote control directly at the infrared sensor installed on the front of the spotlight. The maximum range is about 8 metres.
BL / ON/OFF (Blackout)
The BL button is used to switch off the spot, regardless of the mode selected. Pressing the BL button once more, re-activates the previously selected
mode.
SP / SPEED
11-level speed setting for "Auto Jump", "Auto Fade" and "Auto Program" modes. First, press the SP button and then select the desired speed using
the + and - buttons. Level 1 makes the colour change sequence run slowly. Pressing again, activates level 2 with a faster colour change sequence,
followed by levels 3 to 10, whereby level 10 corresponds to the fastest colour change sequence.
/ BRIGHTNESS
Setting the brightness in 12 levels. First, press the
FL / FLASH (Strobe)
Enabling and setting the strobe effect in 14 speed levels. After pressing the FL button, select the flash frequency (14 levels) using the + and - buttons
(Level 1 = strobe disabled, Level 2 = slowest flash frequency, Level 14 = fastest flash frequency)
R / G / B / W / A / U (red, green, blue, white / A and U without function)
These 6 buttons can be used to create individual colour combinations. The 12 levels of brightness can be selected by pressing the corresponding
colour button, then using the + and - buttons, whereby, at level 1, the LEDs are switched off.
For example: If you set red and green to the respective highest level and blue and white to the lowest, i.e. off, the result will be a bright yellow colour
mixture.
PG (Auto Jump / Auto Fade)
Press the PG button and then select the desired mode "Auto Jump" or "Auto Fade" using the + and - buttons. Select the speed at which the pro-
grams are running, using the SP (Speed) and + and - buttons.
CM (Colour Macros)
15 Colour presets that can be accessed using the CM and + and - buttons.
SC (music-controlled colour change program)
To activate the sound-control mode, press SC and then use the + and - buttons as required to select the microphone sensitivity (11 levels).
AU (Auto program)
Automatic toggle between "Auto Jump" and "Auto Fade". The program speed is adjusted using the SP, and + and - buttons.
DE
Aktivieren Sie in den Systemeinstellungen unter „IR Remote" die Steuerung durch die Infrarot Fernbedienung (IR Remote On).
Richten Sie nun die Infrarot-Fernbedienung in Sichtverbindung direkt auf den auf der Vorderseite des Strahlers verbauten
Infrarot-Sensor. Die maximale Reichweite beträgt ca. 8 Meter.
BL / ON/OFF (Blackout)
Die BL-Taste dient dazu, den Strahler abzuschalten, unabhängig davon, welche Betriebsart aktiviert ist. Bei nochmaligem Drücken der BL-Taste wird
die zuvor ausgewählte Betriebsart wieder aktiviert.
38
button and then select the desired brightness using the + and - buttons (Level 1 = blackout)

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Clqs15rgbwClqs15rgbwwh

Tabla de contenido