Aventics HF03 Instrucciones De Servicio página 58

58 AVENTICS | HF03/HF02 | 1987765472–BDL–001–AB
Installation
Valve position
GND Pin a1
Solenoid/LED 12 Pin b1
Solenoid/LED 14 Pin c1
a
b
c
Fig. 8: Mating plug I assignment
Mating plug assembly
1 2 3 4
a2 a3 a4 a5 a6 a7 a8 a9 a10
b2 b3 b4 b5 b6 b7 b8 b9 b10 b11 b12 b13 b14 b15 b16
c2 c3 c4 c5 c6 c7 c8 c9 c10 c11 c12 c13 c14 c15 c16
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
1. Select a suitable sealing element and insert it into the
mating plug's terminal fitting:
– red: cable Ø 9.0 ... 13.0 mm
– white: cable Ø 11.5 ... 15.5 mm
2. Push the terminal fitting and mating plug casing over the
cable.
3. Remove about 5 cm of the cable sheath. Remove about
5 mm of insulation from the strands and mark them
according to their assignment and function.
4. Crimp the plug connections to the single cable strands.
5. Click the plug connections into the socket body according to
the assignment.
6. Screw the socket body to the mating plug casing; pay
attention to the orientation (different pin Ø on the mating
plug provide clarity).
7. Tighten the terminal fitting's lock nut until the sealing
element firmly holds the cable (IP 65 degree of protection,
strain relief).
5 6 7 8 9 10 11 12 13
Reserved, do not assign!
a
b
c
14 15 16