Product Description; Structure; Principle Of Operation; Packaging, Transport And Storage - Vega VEGABAR S 16 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Product description

2 Product description

2.1 Structure

Scope of delivery
The scope of delivery encompasses:
VEGABAR S 16 process pressure transmitter
l
Documentation
l
this operating instructions manual
-

2.2 Principle of operation

Application area
VEGABAR S 16 is a pressure transmitter for
measurement of gauge pressure, absolute pres-
sure or vacuum. Measured products are gases,
vapours and liquids.
Functional principle
The sensor element is the CERTEC
cell with rugged ceramic diaphragm. The process
pressure causes a capacitance change in the
measuring cell via the ceramic diaphragm. This
change is converted into an appropriate output
signal and outputted as measured value.
Voltage supply
Two-wire electronics 4 ... 20 mA for power supply
and measured value transmission over the same
cable.

2.3 Packaging, transport and storage

Packaging
Your instrument was protected by packaging
during transport. Its capacity to handle normal
loads during transport is assured by a test
according to DIN EN 24180.
The packaging of standard instruments consists of
environment-friendly, recyclable cardboard. For
special versions, PE foam or PE foil is also used.
Dispose of the packaging material via specialised
recycling companies.
Transport
Transport must be carried out under consideration
of the notes on the transport packaging. Non-
observance of these instructions can cause dam-
age to the device.
16
Transport inspection
The delivery must be checked for completeness
and possible transit damage immediately at re-
ceipt. Ascertained transit damage or concealed
defects must be appropriately dealt with.
Storage
Up to the time of installation, the packages must be
left closed and stored according to the orientation
and storage markings on the outside.
Unless otherwise indicated, the packages must be
stored only under the following conditions:
l
l
l
l
l
Storage and transport temperature
l
®
measuring
l

3 Mounting

3.1 General instructions

Suitability for the process conditions
Make sure that all parts of the instrument exposed
to the process, in particular the sensor element,
process seal and process fitting, are suitable for
the existing process conditions. These include
above all the process pressure, process temper-
ature as well as the chemical properties of the
medium.
You can find the specifications in chapter "Tech-
nical data" or on the type label.

3.2 Mounting instructions

Mounting position
VEGABAR S 16 functions in any installation
position.
Not in the open
Dry and dust free
Not exposed to corrosive media
Protected against solar radiation
Avoiding mechanical shock and vibration
Storage and transport temperature see chapter
"Supplement - Technical data - Ambient con-
ditions"
Relative humidity 20 ... 85 %
VEGABAR S 16

Publicidad

Tabla de contenido
loading

Tabla de contenido