Vega VEGABAR S 16 Manual De Instrucciones página 18

Connecting to power supply
1
Fig. 10: Connection to the screw terminals
1
Cable gland
2
Plug housing
3
Plug insert
4
Plug seal
Snap the plug insert into the plug housing and
7
insert the sensor seal
Plug the plug insert with seal to VEGABAR S
8
16 and tighten the screw
The electrical connection is finished.
Connection via angle plug connector with
hinged cover
Proceed as follows:
Loosen the screw in the cover of the plug
1
connector
Open the cover and remove it
2
Press the plug insert downwards
3
Loosen the screws of the strain relief and cable
4
entry
1
1
3
2
Fig. 11: Loosen the plug insert
1
Plug insert
2
Strain relief
3
Cable gland
4
Plug housing
18
2
3
4
2 3
4
Remove approx. 5 cm of the cable mantle, strip
5
approx. 1 cm insulation from the individual
wires
Lead the cable through the cable gland into the
6
plug housing
Connect the wire ends to the screw terminals
7
according to the wiring plan
1
Fig. 12: Connection to the screw terminals
1
Cable gland
2
Cover
3
Plug housing
4
Plug insert
5
Plug seal
Snap the plug insert into the plug housing and
8
insert the sensor seal
Information:
Note the correct arrangement, see illustra-
tion
Tighten the screws on the strain relief and
9
cable entry
10 Hook in the cover and push onto the plug
connection, tighten cover screw
11 Plug the plug insert with seal to VEGABAR S
16 and tighten the screw
The electrical connection is finished.
2
3
4
5
VEGABAR S 16