Adjusting Subwoofer Settings; Using The High Pass Filter - Pioneer DEH-P55BT Manual De Instrucciones

Audio Adjustments
# To turn subwoofer output off, push
MULTI-CONTROL down.
3 Push MULTI-CONTROL left or right to
select the phase of subwoofer output.
Push MULTI-CONTROL left to select reverse
phase and SUB W:REV appears in the display.
Push MULTI-CONTROL right to select normal
phase and SUB W:NOR appears in the dis-
play.

Adjusting subwoofer settings

When the subwoofer output is on, you can ad-
just the cut-off frequency and the output level
of the subwoofer.
1 Press AUDIO to select S/W.
Press AUDIO until S/W appears in the dis-
play.
# When the subwoofer output is on, you can se-
lect S/W.
2 Push MULTI-CONTROL left or right to
select cut-off frequency.
Each time MULTI-CONTROL is pushed left or
right, cut-off frequencies are selected in the
following order:
50—63—80—100—125 (Hz)
Only frequencies lower than those in the se-
lected range are outputted from the subwoo-
fer.
3 Push MULTI-CONTROL up or down to
adjust the output level of the subwoofer.
Each time MULTI-CONTROL is pushed up or
down, subwoofer level increases or decreases.
+6 to –24 is displayed as the level is increased
or decreased.

Using the high pass filter

When you do not want low sounds from the
subwoofer output frequency range to play
from the front or rear speakers, turn on the
HPF (high pass filter). Only frequencies higher
than those in the selected range are outputted
from the front or rear speakers.
1 Press AUDIO to select HPF.
Press AUDIO until HPF appears in the display.
# When the F.I.E. function is on, you cannot se-
lect HPF.
2 Push MULTI-CONTROL up to turn high
pass filter on.
80 appears in the display. High pass filter is
now on.
# If the high pass filter has been previously ad-
justed, the frequency of that previously selected
will be displayed instead of 80.
# To turn high pass filter off, push
MULTI-CONTROL down.
3 Push MULTI-CONTROL left or right to
select cut-off frequency.
Each time MULTI-CONTROL is pushed left or
right, cut-off frequencies are selected in the
following order:
50—63—80—100—125 (Hz)
Only frequencies higher than those in the se-
lected range are outputted from the front or
rear speakers.
Section
12
61
En