Maytag BRAVOS Serie Manual De Uso Y Cuidado página 19

Press START. [he countdown in hours to the wash cycle will show in the time display
window and the indicator light will begin to flash.
NOTE: [he Start indicator light will not flash when [Delay Wash is chosen. You must press
Start to initiate a countdown for the cycle to begin.
To change the Delay Wash time:
• Press PAUSE/CANCEl.
• Press DELAY WASH to select the desired delay time.
• Press START to begin the countdown.
To cancel Delay Wash:
Press START again to begin the cycle right away or press PAUSE/CANCEl twice.
Use these pads to select the desired options for your wash cycle.
(9
STAIN
CYCLE
Low
PRE- END OF
SOAK CYCLE
SIGNAL
Stain Cycle
This option provides enhanced cleaning action for tough stains. The Super Wash cycle
automatically includes Stain Cycle. Choosing Stain Cycle will add approximately 5 minutes
to a cycle. Stain Cycle should be started on a dry load only and cannot be selected after the
tub has started filling with water.
Stain Cycle may be selected as an option with other cycles. See table for details.
Cycle Stain Cycle
(Adds time to the wash cycle)
Whites Option
Super Wash Default
Bulky Not available
Sheets Not available
Cycle Stain Cycle
(Adds time to the wash cycle)
Delicate Option
Handwash Option
Clean Washer with bleach only Not available
Soak Not available
Rinse & Spin Not available
Spin Only Not available
Extra Rinse
An extra rinse can be used to aid in the removal of detergent or bleach residue from garments.
[his option provides an additional rinse with the same water temperature as the first rinse.
[his is the default rinse setting for the Whites cycle.
I
Pre Soak
Use this option for set-in stains and soil that need extra time for removal. Soaking ill this
washer is different than in a conventional washer. ]he washer sprays the load with water and :::ii
detergent at extra-low spin speed followed by a brief period of wash action at the speed of the
selected cycle. This action is repeated. Pre Soak cycles through a series of sprays and wash
actions followed by a pause to allow the detergent to work on the soils. ]he Pre Soak feature
is followed by the selected cycle. Using Pre Soak will extend your wash cycle.
End of Cycle Signal Volume
[he End of Cycle Signal produces an audible sound when the wash cycle is finished. This
signal is helpful when you are removing items from the washer as soon as it stops. Select
High, I.ow or Off.
POWER
©
START
PAUSE/
CANCEL
®
LID L_CK
Normal Option
Wrinkle Control Option
Colors/Jeans Option
Quick Wash Option
Powe r
Press POWER to turn tile washer on or off.
19