Maytag BRAVOS Serie Manual De Uso Y Cuidado página 9

Laundry tub drain or standpipe drain
Connecting the drain hose form to the corrugated drain hose
T
4.5"
(11.4 cm)
A. Drain hose mlMf_
1. F_'ed end o[ drain hose into one end of form. Place end of drain hose
form into the drain hose relief.
2. Bend the hose over the top of the form and fe'ed into the other end of
the form. Attach the other end of the form into the other drain hose
relief. The hose must extend 4 _//" ( 11.4 crn) beyond the form.
To keep drain water from going back into the washer:
• Do not force excess drain hose into standpipe. Hose should be secure but loose enough
to provide a gap for air.
• Do not lay excess hose on the bottom of the laundry tub.
Floor drain
Do not install the drain hose form on to the corrugated drain hose. You may need additional
parts. See Floor drain under "Fools and Parts."
ll e "
Insert new flat washers (supplied) into each end of the inlet hoses. Firmly seat the washers
in the couplings.
@
A B
A. Coupling
B. Washer
Connect the inlet hoses to the water faucets
Make sure the washer basket is empty.
2. Attach the hose labeled hot to the hot water faucet. Screw on coupling by hand until it is
seated on the washer.
3. Attach the hose labeled cold to the cold water faucet. Screw on coupling by hand until it
is seated on the washer.
4. Using pliers, tighten the couplings with an additional two-thirds turn.
light_ul the couplings with an additional two-thirds turll.
NOTE: Do not overtighten or use tape or sealants on the valve. [Damage to the valves can
result.
Clear the water lines
• Run water through both faucets and inlet hoses, into a laundry tub, drainpipe or bucket,
to get rid of particles in the water lines that might clog the inlet valve screens.
• Check the temperature of the water to make sure that the hot water hose is connected to
the hot water faucet and that the cold water hose is connected to the cold water faucet.