Comfort Adjustments - Vermeiren Sigma Manual De Instrucciones

EN
NL
3.7

Comfort adjustments

CAUTION
•
The following comfort adjustments can be done by the attendant or caretaker. All other
adjustments are done by your specialist dealer according to the installation instructions, see
preface.
•
Always keep the swing range of footrest and operating console in mind to prevent
bystanders from getting injured or objects from being damaged.
•
Make sure that your fingers, clothes, buckles don't get trapped during adjustment.
3.7.1 Armrests
Position
The armrests can be turned backwards (up) to make it easier to
transfer to/from the seat.
1. Push lever (31) of the toothed clamp (30) slowly down. The arm
rest is unlocked (in bottom position).
2. Turn the armrest up/backwards to its end position.
3. Pull lever (31) up to close the toothed clamp. The armrest is
locked in end position.
Angle
The same procedure is used to change the angle of the
armrest:
1. Repeat previous step 1.
2. Next, hold the armrest in the desired position, while
locking it with the lever (31).
3. Repeat this for the second armrest.
4. Make sure that both armrests have the same angle.
5. Make sure that both armrests are firmly secured.
3.7.2 Arm pads
The arm pads (3) can be adjusted in height (stepless) and angle (7,5° step):
1. Turn the star knob (32) a few turns anticlockwise. To
adjust the angle, turn it four turns minimally.
2. Pull/push the arm pad lightly to adjust the height.
3. Hold the arm pad at the desired angle.
4. Turn the star knob clockwise until it is finger-tight.
5. Repeat this for the second arm pad.
6. Make sure that both arm pads are firmly secured.
Risk of injuries or damage
3
16
Sigma, Sigma 230
2019-08
Using your wheelchair
12
31
32
31
30