Hilti PR 300-HV2S Manual De Instrucciones página 43

6.4.1 Using the PRA 300 laser receiver as a hand-held tool
1. Press the on/off button
NOTE If the receiver was switched on before the PR 300 rotating laser was started, a laser beam will not yet be
shown in the receiver's display.
2. Hold the laser receiver with the detection area directly in the plane of the rotating laser beam.
6.4.2 Working with the laser receiver in the PRA 83 receiver holder 10
1. Push the receiver into the rubber sleeve of the PRA 83 at an angle until it fully encloses the receiver. Take care to
ensure that the detection area and the keys are facing the front.
2. Fit the receiver, complete with the rubber sleeve, onto the grip section. The cover and grip section are joined
together by the magnetic holder.
3. Switch the receiver on by pressing the on/off button
4. Turn the rotating grip to the open position.
5. Secure the PRA 83 receiver holder on the telescopic staff or leveling staff by tightening the clamping knob.
6. Hold the laser receiver with the detection area directly in the plane of the rotating laser beam.
6.4.3 Working with the PRA 81 height transfer device 10
1. Open the catch on the PRA 81.
2. Insert the laser receiver in the PRA 81 height transfer device.
3. Close the catch on the PRA 81.
4. Switch the laser receiver on by pressing the on/off button
5. Hold the laser receiver with the detection area directly in the plane of the rotating laser beam.
6. Position the laser receiver so that the distance display shows "0".
7. Use the measuring tape to measure the desired distance.
6.5 Menu options on the PRA 300 laser receiver / remote control unit
1.
The "Menu" key may be pressed at any time during operation.
The menu then appears in the display.
2.
Use the arrow keys
NOTE The arrow keys
selected.
3. You can leave the menu again at any time by pressing the "Menu" key
6.5.1 Setting the volume level
The laser receiver is set to "Normal" volume every time it is switched on. The volume can be adjusted by way of the
"Volume" function in the menu. One of four settings can be selected: "Low", "Normal", "High" or "Off". After making a
selection you are returned automatically to the normal operating mode.
.
or , as required, to select the individual items from the menu.
or let you select the various settings. Press the
Volume level
Units
System setup
Tool setting
Information
Back
Volume high
.
.
key to save the settings you have
or the "Back" key
en
.
35