System Setup; Activating / Deactivating Sleep Mode - Hilti PR 300-HV2S Manual De Instrucciones

en
Press the "Back" key
6.5.2 Setting the units
Using the units function from the menu you can set the desired accuracy of the digital display in millimeters or inches.
After making each selection you are returned automatically to the normal operating mode or, alternatively, pressing
the "Back" key will take you back to the menu.
Units

6.5.3 System setup

The following items appear in the menu: "Activate / deactivate beam shields"
6.5.3.1 Activating/deactivating the beam shields
The laser beam from the PR 300-HV2S can be shut off at one or more sides of the tool. This feature is useful when
you are using several laser tools simultaneously on the jobsite and it is necessary to prevent reception of the beam
from more than one laser tool. The laser plane is divided into four quadrants. These are marked on the casing of the
tool and can be set as follows:
1. In the menu
2. Select the "Activate / deactivate beam shields" function
3. Use the arrow keys
4. Activate / deactivate the desired quadrants by pressing the OK key
5. Confirm this setting by pressing the OK key
If the quadrant is visible its status is "On". If the quadrant is not visible its status is "Off".
6.
Press the "Back" key
normal operating mode.
NOTE Settings that affect the rotating laser only become effective when the rotating laser is switched on and a
wireless connection has been established.

6.5.3.2 Activating / deactivating sleep mode

The PR 300-HV2S saves power when in sleep mode. The laser is switched off, thereby extending battery life.
1. Press the "Menu" key
2. Select system setup
3.
Use the arrow keys
4. Confirm your selection by pressing the OK key
36
Volume normal
Volume low
Volume off
if you wish to return to the menu.
1 mm
2 mm
5 mm
10 mm
25 mm
, select the system settings
to navigate to the correct quadrant.
to return to the "System setup" menu item
on the PRA 300.
.
to navigate to the option "Sleep mode"
and confirm your selection by pressing the
and confirm your selection by pressing the
.
.
.
.
¹⁄₁₆"
¹⁄₈"
¹⁄₄"
¹⁄₂"
1"
and "Sleep mode" .
key.
or press the "Menu" key
key.
to return to