ORIGINAL OPERATING INSTRUCTIONS
DD 200 diamond core drilling system
It is essential that the operating instructions
are read before the machine is operated for
the first time.
Always keep these operating instructions
together with the machine.
Ensure that the operating instructions are
with the machine when it is given to other
persons.
Operating controls, parts and indicators
Drilling rig (drive unit and drill stand)
Drive unit
; Service indicator
= Drilling performance indicator
% On / off switch
& Gear selector switch
( Water flow regulator
) Chuck
+ Supply cord with PRCD
§ Carrying grips (2)
/ Water hose connector
: Type plate
· Interface
Drill stand
$ Column
£ End cap
| Strut
¡ Base plate
Q Clamping spindle
W Clamping nut
E Anchor
R Leveling screws
T Hole center indicator
Contents
1. General information
Printed: 22.11.2013 | Doc-Nr: PUB / 5069597 / 000 / 03
Z Carriage
U Drive unit (eccentric) locking bolt
I Direct drive
O Reduction gear
P Carriage locking mechanism
Ü Hand wheel
[ Carrying grip
] Supply cord guide
Æ Type plate
º Leveling indicators (2)
• End stop
A Wheel assembly mounting point
ACCESSORIES
Vacuum base plate
S Pressure gauge
D Vacuum release valve
F Vacuum seal
G Vacuum hose connector
H Wheel assembly mounting point
Water flow indicator
J Water flow indicator
Water collector system
K Water collector holder
L Water collector
Ö Seal
Ä Seal
1. General information
1.1 Safety notices and their meaning
-DANGER-
Draws attention to imminent danger that will lead to seri-
ous bodily injury or fatality.
-WARNING-
Draws attention to a potentially dangerous situation that
could lead to serious personal injury or fatality.
Page
17
-CAUTION-
19
Draws attention to a potentially dangerous situation that
could lead to slight personal injury or damage to the
19
equipment or other property.
19
21
-NOTE-
Draws attention to an instruction or other useful infor-
23
mation.
26
28
1.2 Pictograms
29
Prohibition signs
30
31
Transport by
crane is not
31
permissible.
en
17