Installation; Opening The Enclosure - Mettler Toledo IND256x Guia De Instalacion

2

Installation

2.1.

Opening the Enclosure

Open IND256x terminal according to the steps in the following sections.
The front cover of the IND256x terminal is attached by 4 screws. For hardware configuration inside
the instrument, open it as shown below:
1. Place the terminal face-down on a flat surface, taking care not to damage the fascia.
2. Unscrew the four captive screws indicated in Figure 2-1.
30491430 | 02 | 11/2019
DO NOT INSTALL OR PERFORM ANY SERVICE ON THIS EQUIPMENT BEFORE THE AREA HAS
BEEN SECURED AS NON-HAZARDOUS BY PERSONNEL AUTHORIZED TO DO SO BY THE
RESPONSIBLE PERSON AT THE CUSTOMER'S SITE.
CONFIRM COMPLIANCE WITH APPLICABLE NATIONAL AND LOCAL WIFI REGULATIONS BEFORE
INSTALLING AND COMMISSIONING IND256x TERMINAL CONFIGURED WITH WIFI MODULE.
METTLER TOLEDO ACCEPTS NO RESPONSIBILITY FOR TERMINAL INSTALLATION IN COUNTRIES
WHERE WIFI REGULATIONS ARE NOT FULFILLED.
TO PREVENT IGNITION OF HAZARDOUS GAS, BE SURE TO CUT OFF THE POWER BEFORE
OPENING IND256X ENCLOSURE. AFTER IND256X IS POWERED ON, KEEP THE ENCLOSURE
STRICTLY SEALED. DO NOT OPEN THE CASE IN THE PRESENCE OF EXPLOSIVE DUST OR GAS.
Figure 2-1: Enclosure screws
METTLER TOLEDO IND256x Weighing Terminal Installation Manual
WARNING
CAUTION
WARNING
2-1