Connecting To Network - Yamaha R-N602 Manual De Instrucciones

There are several methods to connect the unit to a network. Select a connection method according to your environment.
Notes
• Some security software installed on your PC or the firewall settings of network devices (such as a router) may block the access of the
unit to the network devices or the Internet. In these cases, configure the security software or firewall settings appropriately.
• Each server must be connected to the same subnet as the unit.
• To use the service via the Internet, broadband connection is strongly recommended.
When playing a high-resolution audio source via the network, we recommend connecting with a wired router for stable playback.
■ Connecting with the MusicCast CONTROLLER app
See MusicCast Setup Guide for details.
■ Connecting with the wired router
Connecting using the DHCP server function of the
router
■ Connecting with a wireless router (access point)
Connect to the network with the method listed below that corresponds to your environment.
Connecting using the Wi-Fi setting of the iOS
device (iPhone / iPod touch)
Connecting using WPS push button configuration
on the wireless router (or access point)
Connecting with a wireless router (access point)
without WPS push button configuration
■ Connecting without a wired router or wireless router (access point)
Connecting wirelessly to a mobile device
(Wireless Direct)
Note
When the unit is connected to the network with Wireless Direct, it cannot connect to any other wireless router (access point). To play
back contents from the Internet, connect this unit to a network with a wired router or wireless router (access point).

Connecting to network

Connecting to network
You can connect to the network by
simply making a wired connection
(p. 14)
Share the Wi-Fi setting of the iOS
device (p. 16)
Use the WPS push button
configuration (p. 17)
Set the network connection
manually (p. 18)
Connect wirelessly with Wireless
Direct (p. 19)
15
En