lamber L24-ek Manual Del Usuario página 22

until the reachig of the exact temperature
(thermocontrol).
Endless cycle (maximum 15 minutes) : the
-
hood being closed and the cycle put on (any
cycle), keep the button "B" pressed for 3
seconds: lamps 1 and 2 will flash at the same
time (thermocontrol excluded); the cycle can be
interrupted at any time pressing again button "C"
that will let final sequences start.
Stand-by : the hood being open, keep the
-
button "B" pressed for 3 seconds (lamp "E" will
stop lightening): if you then close the hood, the
machine does not start the washing cycle keeping
heating functions still working. To start the cycle
press button "C".
- Self-washing cycle : Remove the overflow
from the tank and close the dishwasher hood
while the machine is on (time 10 minutes).
G – Extract the basket inclining it and shake it
carefully, so that the remaining drops can fall
down.
Leave the dishes in the basket until they will be
dry by evaporation. Take the dishes away from
the basket and pay attention not to touch the
dishes internally on its border and put them on
clean shelves.
In order to continue the washing, load another
basket and close the hood.
automatically start again.
ACHIEVEMENTS
Any deficiency in the washing process is
obvious when dirty residuals are visible. Any
halos might be caused by an insufficient rinsing:
in this case, check that the rinsing jets are clean
and that there is a sufficient pressure in the
water distribution network.
In case you find residuals, check that:
• the washing jets are clean
• there is some detergent
• the pump suction filter is clean
• objects in the rack are placed in a correct
position.
RINSING ADDITIVES
To grant a perfect rinsing, a quick drying and to
avoid calcareous sediments on glasses and
cups you must add a surfactant on water
(Brightener).
Your cleansing agent supplier's will be able to
suggest the most
machine is equipped with a rinse aid dispenser.
Mean concentration used is 0,15 g/lt.
The cycle will
suitable product. Your
DISHES POSITIONING
It is suitable to place dishes inside the plastic
basket with the concave side facing upwards.
Place mixed cutlery in a vertical position into
the suitable container minding not to cram them
and with handgrips towards the bottom (see
draw).
DRAIN PUMP INSTRUCTIONS
(only for machines with drain pump)
The drain pump works automatically only
during the washing cycle to discharge the
exceeding water coming from the rinsing cycle.
At the end of the working day, in order to
completely discharge the tank, it is necessary
to perform the following operations:
1. Open the hood of the dishwasher
2. Remove the overflow pipe from the tank;
3 . Afterwards push button "F" for 3 seconds.
Control lamp "E" and the cycle lamp (the last
chosen) are flashing alternatively.
The discharge will stop automatically after 5
minutes. Control lamps will stop flashing.
Please note: in case the hood is open the control
lamp "E" will continue to flash.
Reinstall the overflow and shut the hood.
22