Stihl FH Manual De Instrucciones página 13

FS
HT
SP
FH
SP 10
Loosen the clamp screws (arrows)
N
on the gearbox housing – do not
remove them.
Pull the gearbox off the drive tube.
N
If the drive shaft slips out of the tube
when you pull off the gearbox:
Push the drive shaft into the tube.
N
L
The drive shaft must not project from the
tube more than L = 22 mm (7/8 in).
If dimension (L) is not correct:
Apply slight pressure to the drive
N
shaft and rotate it slowly at the same
time until it can be pushed in to the
specified length.
Mounting the Gearbox
11
10 10
5
Loosen the clamp screws (10).
N
Push the gearbox (11) onto the
N
drive tube (5), turn the gearbox (11)
back and forth as necessary.
English
11