Starting / Stopping The Engine; Lubricating The Gearbox - Stihl FH Manual De Instrucciones

English
Starting / Stopping the
Engine
Starting the Engine
Always follow the starting procedure
described in the basic power tool
instruction manual.
Position the unit securely for
N
starting: It must rest on the machine
support and the blade gearbox.
On units with adjustable cutter bar:
N
Set the cutter bar to the straight (0°)
position.
Remove the blade scabbard. Check
N
that the cutting blades are not
touching the ground or any other
obstacles. If necessary, rest the
gearbox on a raised support (e.g.
mound, brick or something similar).
16
Make sure you have a safe and
N
secure footing.
Hold the unit firmly on the ground
N
with your left hand and press down
– do not touch the throttle trigger or
trigger interlock.
NOTICE
Do not stand or kneel on the drive tube.
WARNING
The cutting attachment may begin to
move as soon as the engine starts. For
this reason, blip the throttle after starting
– the engine returns to idling speed.
Now follow the starting procedure
described in the basic power tool
instruction manual.
Stopping the Engine
See basic power tool instruction
N
manual.

Lubricating the Gearbox

Blade Drive Gear
Lubricate the blade drive gear with
STIHL gear lubricant for hedge trimmers
(Special Accessory).
Check the lubricant level at regular
N
intervals of about every 25 hours of
operation. Unscrew the filler
plug (1) – if no grease can be seen
on the inside of the filler plug, screw
the tube of grease into the filler hole.
Squeeze up to 5 g (1/5 oz.) grease
N
into the gearbox.
NOTICE
Do not completely fill the gearbox with
grease.
Unscrew the tube of grease from the
N
filler hole.
Refit the filler plug and tighten it
N
down firmly.
FH