Stihl FH Manual De Instrucciones página 14

English
11
12
Once the end of the drive tube is
inserted beyond the slot in the
clamp (12):
Push the gearbox (11) fully home as
N
far as stop.
Tighten down the clamp screws
N
moderately.
Line up the gearbox (11) with the
N
powerhead.
Tighten down the clamp screws
N
firmly.
12
Models with Loop Handle
A
Loosen the screws on the loop
N
handle.
Align the loop handle (2) and move
N
it to the most comfortable position.
Distance A must not be more than A =
20 cm.
Tighten down the screws on the
N
loop handle.
Fitting the Carrying Ring
A carrying ring is necessary if the power
tool is to be used with a shoulder
strap/harness. Not all versions of basic
power tools are equipped with a carrying
ring.
The carrying ring is available as a
special accessory and is mounted as
described below.
2
2
Mount the carrying ring (1) about
N
5 cm (A) forward of the control
handle (2).
Push the carrying ring (1) over the
N
drive tube.
Insert the M5 nut (3) in the hex
N
recess in the carrying ring.
Fit the M5x14 screw (4).
N
Line up the carrying ring.
N
Tighten down the screw firmly.
N
A
1
4
3
FH