Dedicated Flash Functions - Metz mecablitz 52 AF-1 Manual De Instrucciones

• When you activate the flash, there should
be no opaque material directly in front of or
on the reflector cover (flash window). The
intense energy emissions can otherwise
lead to scorching or spotting of the material
and/or the reflector cover.
• After a series of flashes with full power
and short intervals, a pause of at least
3 minutes must be observed after each
series of 20 flashes!
• When taking a series of flash shots at full
light output and with rapid recycling times,
and with zoom positions of 35 mm and
less, the diffuser heats up, due to the high
level of thermal energy!
• This flash unit may be used in combination
with a camera-integrated flash only if the
flash can be folded out completely!

2 Dedicated flash functions

Dedicated flash functions are flash functions
that have been specially adapted to a given
camera system. Depending on the type of
camera, different flash functions are
supported.
• Flash-ready indication in camera
viewfinder/camera display
• Automatic flash sync speed control
• Automatic fill-in flash control
TTL
• TTL flash mode ( )
• Preflash TTL and ADI metering
TTL
• Manual flash TTL ( ) exposure
correction
• 1st or 2nd curtain synchronisation (REAR)
(Camera setting)
TTL
• Automatic FP short sync for
• Automatic motor zoom control
• Extended zoom mode
• Automatic AF measuring beam control
• Automatic flash range indication
• Programmed auto flash mode
• Wireless remote flash mode
• Servo mode
• Spot zoom mode
• Wake-up function for the flash unit
• Firmware updates
M
and
k
143