Shooting Format Adjustment (Zoom Size); Remote Mode (Remote); Metre - Feet Commutation (M / Ft); Zoom Position Of The Flash Reflector - Metz MECABLITZ 76 MZ-5 digital Manual De Instrucciones

For system reasons the extended zoom mode is supported for a focal
length of lens from 28 mm. The flash unit must be equipped with a
suitable SCA adapter from the SCA 3002 system and the camera must
supply the data for the focal length of the lens to the flash unit.
After the activation of the extended zoom mode, E-Zoom appears in the
display next to the focal length.
Setting procedure see cap. 8.

8.5 Shooting format adjustment (zoom size)

When operating a digital camera with a suitable SCA adapter from the
SCA 3002 system the display for the reflector position can be adjusted to the
chip format (dimensions of the picture recording component).
• "Size ON" in the display indicates that the shooting format adjustment is
activated.
• "Size OFF" in the display indicates that the shooting adjustment is deacti-
vated.
After the activation of shooting format adjustment, S-Zoom appears in the
display next to the focal length.
For more details, see the operating instructions of the camera and
SCA adapter.
Setting procedure see cap. 8.

8.6 Remote mode (remote)

With this special function the flash unit can be activated as controller or slave
in the cordless Metz remote mode. Here the following settings are possible:
• Remote OFF
• Remote Co1; the flash unit functions as controller with address 1.
• Remote Co2; the flash unit functions as controller with address 2.
When the controller mode is activated the symbol Co. flashes beneath the
display for flash mode.
When operating the control unit with the slave adapter SCA 3083 digital,
84
the following settings are possible:
• Remote Sl1; the flash unit functions as slave with address 1.
• Remote Sl2; the slave functions as slave with address 2.
When the slave mode is activated, the symbol SL flashes under the display
for the flash mode.
For the slave mode the flash unit must be switched to the flash mode
TTL (see 6)!
For more details on the cordless Metz remote mode see chapter 17.
Setting procedure see cap. 8.
8.7 Metre – feet commutation (m / ft)
The maximum flash range in the display of the flash unit can be optionally set
in metres m or feet ft. The setting is made under the menu point m / ft.
Setting procedure see cap. 8.

9. Zoom position of the flash reflector

The adjustment of the zoom position of the flash reflector
a focal length of lens from 24 mm (24 x 36). For lenses with focal lengths
from 20 mm a wide angle diffuser (included) can be used.
The following zoom positions are available:
24 mm – 28 mm – 35 mm – 50 mm – 70 mm – 85 mm – 105 mm
(corresponding to 24 x 36)
When using the wide angle diffuser the zoom reflector must be in the
24 mm position!
Automatic zoom adjustment
If the flash unit is equipped with an SCA adapter from the SCA 3002 system
and is operated with a camera, which reports the data for the focal length of
the camera to the flash unit, the zoom position of its reflector automatically
adjusts to the focal length of the lens. In the display of the flash unit, A-Zoom
and the reflector position (mm) are shown.
can be made for