Tabla de contenido
Publicidad
Problem
Vehicle runs in low speed, but does
not run in high speed (Please Note:
The vehicle is designed to operate
in low speed only in reverse ().)
When the foot pedal is pressed
only one rear wheel spins
Sometimes the vehicle doesn't
run, but other times it does
When the foot pedal is pressed,
the vehicle won't run without
a push
Thermal fuses constantly "trip",
but the vehicle is not over-loaded
nor the driving conditions
too severe
Loud clacking or grinding
noise from a motor-gearbox
Pretend engine doesn't make
sounds or vibrate
Charger gets warm during use
Battery makes a sizzling or
gurgling noise when charging
If, after reviewing the Problems and Solutions Guide, the vehicle still fails to operate, please contact Power Wheels Customer Service.
e Problems and Solutions Guide
Possible Cause
High speed lock-out not disconnected
Operation of vehicle in low speed
Loose wire or connector
Motor or electrical switch damage
Loose wire or connector
"Dead Spot" on motor
Damaged fuse(s)
Child is switching speeds or between
forward and reverse without stopping.
Broken gears
Engine switch OFF
Wrong type or improperly installed batteries
Dead batteries
Loose wires or connectors
It is normal for some chargers to get warm
during use and is not reason for concern.
Some chargers do not get warm during use.
It is normal for some batteries to make
noise and swell slightly while charging
and is not reason for concern. Some
while charging.
Solution
The vehicle was pre-set to run only in low speed. To allow the
vehicle to run in low and high speed, you must disconnect the
High Speed Lock-Out. Follow the instructions on page 37 to
disconnect the High Speed Lock-Out.
It is possible that only one rear wheel may spin when both rear
wheels are raised off the ground and the vehicle is in low speed.
This does not necessarily indicate a problem. Check for proper
operation of the drive system by raising the rear wheels off the
ground and pressing the foot pedal. If only one rear wheel spins,
carefully press your hand on the spinning wheel to slow it down.
The other rear wheel should begin to spin. If the other rear wheel
does not begin to spin, there may be a problem with the vehicle.
Contact Power Wheels
Check all wires around the motors and all connectors to
make sure they are tight.
Contact Power Wheels
Check all wires around the motors and all connectors to make
sure they are tight.
Contact Power Wheels
Contact Power Wheels
Teach your child to stop the vehicle before switching between
speeds or switching direction.
Contact Power Wheels
Make sure the engine switch on the dash is in the ON position.
The pretend engine requires four size "C" alkaline batteries.
Make sure four size "C" alkaline batteries have been properly
installed in the battery compartment.
Replace the batteries with four, fresh, size "C" alkaline batteries.
Never leave dead batteries in the battery compartment.
Check all connections. Make sure the wire connections at the
back of the engine switch plate are secure and that the battery
wire harness connectors (located under the hood and engine
housing) are completely joined.
No action required. If your charger does not get warm during
use, it does not mean that it is not working properly.
No action required. If your battery does not make noise or
swell slightly during charging, it does not mean that it is not
accepting the charge.
42
®
Customer Service
®
Customer Service.
®
Customer Service.
®
Customer Service.
®
Customer Service.
Publicidad
Tabla de contenido
