Reducers Assembly Instructions For Lpg - baltur TBG 45 Manual De Instrucciones

REDUCERS ASSEMBLY INSTRUCTIONS FOR LPG

E
In the event of functioning with LPG fuel connect the appropriate
N
reducers supplied with the burner. For the assembly of the reducers
follow the instructions below.
G
L
TBG 45 PN-V
I
S
H
1) After having loosened the holding screws 1 remove the
reducers A (N.2) from their respective housings.
2) Connect the two reducers B with holes turned
towards the external part of the mixer.
3) Position the holes (C) at the same level of the disk flame
(D) as shown in the figure; fixing in the proper way the new
reducers by turning the respective screws.
In some particular applications, in the event that there are
!
pulsations in the flame during the functioning of the burner
with natural gas, it is advisable to use the intended reducers
for LPG fuel.
TBG 60 PN-V
1) After having
ing screws
(N.2) from their respective housings.
2) Ensure that the reducers output hole is found at the same
level as the disk flame B as shown in the figure; fixing the
new reducers properly by turning the respective screws.
18 / 18
00006081362_201106
loosened the
1 remove the reducers
hold-
A