Reducers Assembly Instructions For Lpg - baltur TBG 45 PN-V Manual De Instrucciones

REDUCERS ASSEMBLY INSTRUCTIONS
FOR LPG
In the event of functioning with LPG fuel connect the appropriate
reducers supplied with the burner. For the assembly of the reducers
follow the instructions below.
TBG 45 PN-V
1) After having loosened the holding screws 1 remove the
reducers A (N.2) from their respective housings.
2) Connect the two reducers B with holes turned
towards the external part of the mixer.
3) Position the holes (C) at the same level of the disk flame
(D) as shown in the figure; fixing in the proper way the new
reducers by turning the respective screws.
In some particular applications, in the event that there are
!
pulsations in the flame during the functioning of the burner
with natural gas, it is advisable to use the intended reduc-
ers for LPG fuel.
TBG 60 PN-V
1) After having
ing screws
(N.2) from their respective housings.
2) Ensure that the reducers output hole is found at the same
level as the disk flame B as shown in the figure; fixing the
new reducers properly by turning the respective screws.
22 / 24
0006081484_201104
loosened the
1 remove the reducers
hold-
A