To Tow The Product - Husqvarna P 520D Manual De Usuario

2. Make sure that the center of gravity of the product is
above the wheel axle of the transport vehicle. If a
trailer is used for transport, make sure that the down
force on the tow bar is correct.
3. Apply the parking brake.
4. Lock the product with .
5. Lower the cutting deck to the mow position.
6. Remove all loose objects.
7. Put the first strap through the rear transmission
frame and attach the strap to 1 of the hooks on the
transmission.
8. Put the second strap through the rear transmission
frame and attach the strap to the other hook on the
transmission.
9. Attach the straps to the load area.
10. Tighten the straps rearward to attach the product to
the load area.
11. Attach the third strap to 1 of the transport eyelets.
12. Attach the fourth strap to the other transport eyelet.
42
13. Attach the strap to the load area.
14. Tighten the strap in the direction of the front of the
load area to attach the product to the load area.
15. Put the wheel blocks in front of and behind the rear
wheels.

To tow the product

The product has a hydrostatic transmission. To prevent
damage to the transmission, tow the product short
distances only and at low speed.
Disengage the transmission before you tow the product.
To release and apply the hydraulic pressure on
Refer to
page 18 .
Storage
Prepare the product for storage at the end of the
season, and before more than 30 days of storage. Tacky
particles from the stored fuel can have a negative effect
on the engine function.
To prevent tacky particles during storage, add a
stabilizer. Add stabilizer to the fuel in the tank or in the
container used for storage. Always use the mixing ratios
given by the manufacturer. Run the engine for a
minimum of 10 minutes after you add the stabilizer until
it flows into the carburetor.
WARNING: Do not keep the product with
fuel in the tank in an indoor location or in
locations with bad airflow. Risk of fire if fuel
fumes come near open flames and sparks.
WARNING: Remove grass and other
flammable materials from the product to
decrease the risk of fire. Let the product
become cool before you put it in storage.
• Clean the product, see
26 . Repair paint damages to prevent corrosion.
• Examine the product for worn or damaged parts and
tighten loose screws and nuts.
• Remove the battery. Clean it, charge it, and keep it
cool during storage.
• Change the engine oil, and discard the waste oil.
To clean the product on page
740 - 004 -