•
Empty the fuel tank. Start the engine and run it until
there is no remaining fuel in the carburetor.
Note: Do not empty the fuel tank and carburetor if a
stabilizer is added.
•
Remove the spark plugs and put about a tablespoon
of engine oil into each cylinder. Manually turn the
engine shaft to apply the oil and attach the spark
plugs.
•
Lubricate all grease nipples, joints and axles.
•
Keep the product in a clean and dry area and cover
it for more protection.
•
A cover for protection of your product during storage
or transport is available at your dealer.
Storage of the cabin
WARNING: Move the cabin carefully. The
cabin is heavy and can cause serious
injuries. Make sure the cabin is stable during
storage.
•
Repair paint damages to prevent corrosion.
•
Examine the product for worn or damaged parts and
tighten loose screws and nuts.
•
Keep the product in a clean and dry area and cover
it for more protection.
•
Keep the product in a locked area away from
children and other not approved persons.
•
Put the cabin on the cabin support during storage.
Cabin support dimensions on page 49 .
Refer to
Disposal
•
Chemicals can be dangerous and must not be
discarded on the ground. Always discard used
chemicals at a service center or an applicable
disposal location.
•
When the product is worn out, send it to the dealer
or to an applicable recycling location.
•
Oil, oil filters, fuel and the battery can have negative
effects on the environment. Obey the local recycling
requirements and applicable regulations.
•
Do not discard the battery as domestic waste.
•
Send the battery to a Husqvarna service agent or
discard it at a disposal location for used batteries.
740 - 004 -
43