To Adjust The Seat; To Release And Apply The Hydraulic Pressure - Husqvarna P 520D Manual De Usuario

servicing dealer more information about fuel for cold
weather.
• Do a check of the fuel level before each use and
refuel if necessary.
• Do not fully fill the fuel tank. Keep a space of a
minimum 4 cm.

To adjust the seat

WARNING: Do not adjust the seat during
operation of the product.
• To adjust the seat forward and rearward, push the
lever (A) below the front edge of the seat. Move the
seat (B) to the correct position.
A
B
• To adjust the suspension of the seat, pull the lever
(C) to the left. Push the lever up for more suspension
and push the lever down for less suspension (D).
C
18
D
• To adjust the backrest, push the lever (E) to the left
of the seat. Move the backrest to the correct
position.
• To adjust the lumbar support, turn the lever (F) to the
left of the backrest. Turn the lever counterclockwise
for more support.
F
To release and apply the hydraulic
pressure
To move the product with the engine off, you must
release the hydraulic pressure. The hydraulic pressure
is released and applied with a bypass valve.
CAUTION: Close the 2 bypass valves
before you operate the product. If they are
open, the transmission can become
damaged.
Rear axle
• To release the hydraulic pressure, open the locknut
(A) ¼–½ turn counterclockwise and then the valve
nut (B) 2 turns counterclockwise.
E
A
B
740 - 004 -