To Attach And Remove The Door; To Attach And Remove The Emergency Door - Husqvarna P 520D Manual De Usuario

9. Put a cloth below the hoses for the air condition.
Note: To prevent coolant leakage, make sure that
the air condition is disengaged when the hoses are
disconnected.
10. Disconnect the couplings on the hoses for the air
condition.
11. Remove the 2 screws and the 2 washers behind the
seat (A).
12. Remove the screw and the washer behind the hoses
for the air condition (B).
13. Remove the screw and the washer at the front of the
door (C).
B
14. Fold the seat forward.
15. Put 2 straps through the door and the emergency
exit.
16. Put the straps 2 turns through the cabin.
16
A
C
17. Attach the straps in the lift loops of the cabin.
18. Carefully lift the cabin in the straps with a lift.
19. Lift the cabin 10 cm above the product.
CAUTION: Make sure that the cabin is
lifted above the bolts.
20. Carefully move the cabin forward.
21. Put the cabin in the cabin support. Refer to
of the cabin on page 43
Attach the cabin in the opposite sequence.

To attach and remove the door

1. Open the door 90 degrees.
2. Pull the gas spring and loosen the ball joint.
3. Lift off the door.
Attach the door in the opposite sequence.

To attach and remove the emergency door

1. Open the lock handle on the emergency door.
2. Remove the hinge pin.
3. Open the door 90 degrees.
4. Lift off the emergency door.
Attach the emergency door in the opposite sequence.
Storage
740 - 004 -