To Charge The Battery; To Do An Emergency Start Of The Engine; Tire Pressure - Husqvarna P 520D Manual De Usuario

Ocultar thumbs Ver también para P 520D:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

To charge the battery

Charge the battery if it is too weak to start the
engine.
Use a standard battery charger.
CAUTION: Do not use a boost charger
or start booster. That will cause damage
to the electrical system of the product.
Always disconnect the charger before starting the
engine.
To do an emergency start of the
engine
If the battery is too weak to start the engine, you can use
jumper cables to do an emergency start. This product
has a 12 V system with negative ground. The product
that is used for the emergency start must also have a 12
V system with negative ground.
To connect the jumper cables
WARNING: Risk of explosion because of
explosive gas that comes from the battery.
Do not connect the negative terminal of the
fully charged battery to or near the negative
terminal of the weak battery.
CAUTION: Do not use the battery of your
product to start other vehicles.
1. Remove the engine cover.
2. Remove the cover for the battery case.
3. Connect one end of the red cable to the POSITIVE
battery terminal (+) on the weak battery (A).
B
A
4. Connect the other end of the red cable to the
POSITIVE battery terminal (+) on the fully charged
battery (B).
740 - 004 -
C
D
WARNING: Do not short circuit the ends
of the red cable against the chassis.
5. Connect one end of the black cable to the
NEGATIVE battery terminal (-) on the fully charged
battery (C).
6. Connect the other end of the black cable to a
CHASSIS GROUND (D), away from the fuel tank
and the battery.
7. Replace the covers.
To remove the jumper cables
Note: Remove the jumper cables in the opposite
sequence to how you connect them.
1. Remove the BLACK cable from the chassis.
2. Remove the BLACK cable from the fully charged
battery.
3. Remove the RED cable from the 2 batteries.

Tire pressure

The correct tire pressure is 150 kPa (1.5 bar / 21.7 PSI)
on all 4 tires.
To put the cutting deck in service
position
1. Obey steps 1–13 in
page 14 .
To remove the cutting deck on
33

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

P 525dP 525d with cabin

Tabla de contenido