To Replace A Low Beam Lamp; To Replace A Parking Lamp; To Replace A Turn Signal Lamp - Husqvarna P 520D Manual De Usuario

3. Disconnect the cables from the broken lamp.
4. Push the broken lamp toward the inner lamp
attachment (B).
5. Lift the outer edge (C) of the lamp to remove the
lamp.
6. Replace the broken lamp. Use the type of lamp as
Technical data on page 44 .
given in
7. Connect the cables to the new lamp.
8. Connect the cables at the connection (A).
A
9. Attach the cover and tighten the 2 screws.
28
B

To replace a low beam lamp

1. Remove the 4 screws that hold the lamp module and
lift it out.
2. Disconnect the cables from the broken lamp.
3. Push the spring lock and remove the lamp.
C
4. Put the new lamp into the lamp housing. Refer to
Technical data on page 44 .
5. Connect the cables to the new lamp.
6. Attach the lamp module and tighten the screws.

To replace a parking lamp

1. Remove the 4 screws that hold the lamp module and
lift it out.
2. Disconnect the cables from the broken lamp.
3. Remove the lamp.
4. Put the new lamp into the lamp housing. Refer to
Technical data on page 44 .
5. Connect the cables to the new lamp.
6. Attach the lamp module and tighten the screws.

To replace a turn signal lamp

1. Remove the 4 screws that hold the lamp module and
lift it out.
2. Disconnect the cables from the broken lamp.
740 - 004 -