Flush Cutting; Angle Adjustment; Recommended Chain Speed - Husqvarna WSC 40 Manual De Instrucciones

Flush cutting

Remove the spray guards for normal cutting and the
transmission cover. Replace the spray guards with the
provided guards for flush cutting.
We recommend that both flush guards are fitted but in
some applications (sawing aligned to the floor or the
ceiling) one guard might be temporarily removed. At least
the guard in the chain direction must be fitted. Replace
the guard after cutting.
16 – English
OPERATING

Angle adjustment

Angle adjustment is used to get a perfect cut in angles
close to ceiling, wall or floor. Adjust the angle to its
maximum position. The direction is depending on the cut.
Loosen the screw and adjust the angle.
!

Recommended chain speed

For best cutting performance, use full cutting speed 28 m/
s (92 ft/s) in soft and medium concrete.
If WS 482 is used, make sure that mechanical gear 2 is
engaged to get correct display of chain speed.
CAUTION! Cutting at too low revs can cause damages
to the chain and chain bar. Check that the correct
mechanical gear is selected! A lower chain speed
should be used when cutting in hard concrete than if
cutting in soft concrete.
WARNING! Always tighten the screw with
tightening torque 20 Nm (15 ft-lbs).