Troubleshooting - Husqvarna K1270 II R Manual De Usuario

Ocultar thumbs Ver también para K1270 II R:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 48
Problem
The product does not start.
The cutting blade rotates at idle
speed.
The cutting blade does not rotate
when the operator throttles up.
The product has no power when the
operator tries to throttle up.
The vibration levels are too high.
The temperature of the product is too
high.
The engine decreases in power or in
speed.
1390 - 001 - 10.01.2020

Troubleshooting

Cause
The start procedure is done incor-
rectly.
The stop switch in the right (STOP)
position.
There is no fuel in the fuel tank.
The spark plug is defective.
The clutch is defective.
The idle speed is too high.
The clutch is defective.
The belt is too loose or defective.
The clutch is defective.
The cutting blade is installed incor-
rectly.
The air filter is clogged.
The fuel filter is clogged.
The fuel tank flow is blocked.
The cutting blade is installed incor-
rectly.
The cutting blade is defective.
A vibration damping unit is defective.
The air intake or the cylinder flanges
are blocked.
The drive belt tension is not suffi-
cient.
The clutch is defective.
The air filter is clogged.
Possible solutions
To start the product with a
Refer to
cold engine on page 8 and To start
the product with a warm engine on
page 10 .
Make sure that the stop switch
(STOP) is in the left position.
Fill with fuel.
Replace the spark plug.
Speak to your service agent.
Adjust the idle speed.
Speak to your service agent.
Tighten the belt or replace the belt
with a new one.
Speak to your service agent.
Make sure that the cutting blade is
correctly installed.
Examine the air filter. If it is necessa-
ry, replace it.
Replace the fuel filter.
Speak to your service agent.
Make sure that the cutting blade is
correctly installed and that it is not
damaged.
Replace the cutting blade and make
sure that it is not damaged.
Speak to your service agent.
Clean the air intake and the cylinder
flanges.
Examine the belt. Adjust the tension.
Always cut at full throttle.
Examine the clutch. Speak to your
service agent.
Examine the air filter. Refer to
amine the air filter on page 18 .
To ex-
19

Publicidad

Tabla de contenido
loading

Tabla de contenido