Assembling The Stand; Caution During Assembly; Other Cautions; Assembly Procedure - Korg G1 Manual De Usuario

Assembling the Stand

Warning
● At least one other person must help you assem-
ble the stand.

Caution during assembly

In order to assemble the stand safely, please observe the fol-
lowing points.
• Make sure that you have the correct part in the correct ori-
entation, and perform the assembly in the order given.

Other cautions

Please check the following points after assembly.
• Loosened screws
The screws may loosen as time passes after assembly. You
should periodically check whether any screws have become
loose. If you feel that the stand vibrates excessively, it is pos-
sible that screws have come loose. If so, re-tighten them.
• When moving the digital piano to another location
To move the assembled stand, remove the AC adapter cord
from the stand, close the key cover, and then move it slowly
with at least two people keeping it as level as possible.
• Disassembly
If you need to disassemble the stand, do so by reversing the
steps of the assembly procedure. After disassembly, keep the
screws and other parts in a safe place so that they are not lost.
The G1/G1 Air should always be laid down before disas-
sembled.

Assembly procedure

You'll need a Phillips (+) screwdriver.
1. Put the protective sheet, which had covered the G1/G1
Air, on a flat floor, and place the G1/G1 Air on that sheet
with its rear facing the floor.
In addition, place cloths or magazines so that you may eas-
ily put your hands under the G1/G1 Air when assembling
and raising the stand.
Protective sheet
2. Make sure that all of the following parts are available.
Side panel (left)
Speaker box
Pedal cord
Pedal unit
Anti-tipping Bracket
(left)
18
G1
Side panel (right)
Pedal board
Anti-tipping Bracket
(right)
Screws (M4)
Screws (M6)
x 12 pcs.
x 4 pcs.
3. While adjusting the gaps between the left and right side
panels and the G1/G1 Air, fasten them together using
four screws (M6)
If it is difficult to align the screw holes, place a cloth
or magazine under the left and right side panels to
adjust their heights.
Screws
(M6)
Side panel (left)
4. Temporarily tighten* the pedal board to the hardware in-
side the side panels of the stand, using four screws (M4).
Be careful not to scratch the side panels.
* To temporarily tighten the screws is to tighten them leav-
ing a clearance of about 2 mm.
Screws
(M4)
Pedal board
Side panel
(left)
5. With the help of another person, slowly stand up the
stand being assembled.
6. Lift up the speaker box so that the brackets (A) on the
left and right side panels pass through the dents in the
speaker box. When the brackets (A) are fully hidden
within the speaker box, push the speaker box forward so
the rear of the speaker box is nearly flush with the edges
of the side panels. Then, the speaker box can be released.
Be careful not to pinch your fingers.
Push rivet x 1 pc.
Cord holder
x 2 pcs.
G1
Screws
(M6)
Side panel (right)
Screws
(M4)
Side panel
(right)
Bracket (A)
Dent
Speaker cord