Battery Care And Installation; Rechargeable Batteries; Battery Installation And Care; Battery Maintenance - MSA EVOLUTION 5000 Manual De Instrucciones

Thermal Imaging Camera

4. Battery Care and Installation

Rechargeable Batteries

The EVOLUTION 5000 TIC is supplied with two Lithium Ion
batteries; only one battery is required for TIC operation.

Battery Installation and care

1. Place the unit on a clean, non-abrasive surface and lean
the unit forward.
2. Unhook the battery latch and open the battery
compartment.
3. Place the battery inside the battery compartment, observe
proper position.
4. Close and latch the battery compartment (see Fig. 7)
Fig. 7: Battery Installation

Battery Maintenance

After each use, inspect:
battery contacts for damage (see Fig. 8).
Fig. 8: Battery Contacts
10
batteries for damage or leakage (see Fig. 9)
Fig. 9: Inspect Battery
to ensure battery charger is functioning properly by:
placing battery into the charger.
checking that the battery charger LEDs react
accordingly.
Note: Batteries not passing this inspection must be
removed from service until the proper repairs are made.

Desk Top Battery Charger

Fig. 10: Desk Top Battery Charger
Warning! This charging system is not rated as "intrinsically
safe." Do not use the system in environments or
atmospheres where static or spark may cause an explosion.
Do not remove the outer housing of the Charger. Only
authorised personnel may service the unit.
The Charger must only be used for charging EVOLUTION
rechargeable Lithium Ion Battery Packs.
Do not use damaged chargers. Do not attempt to charge
damaged packs. Do not use the charger outdoors.
GB
GB